Peak Sun Hours
Peak sun hours express a site's daily solar irradiation as the number of hours at 1,000 W/m² that would deliver the same energy. Five peak sun hours means 5 kWh per square metre in a day, which makes them a quick way to estimate how much a solar array will produce.
Peak sun hours (PSH) are a way of expressing how much solar energy a site receives in a day. The total irradiation on a surface, in kWh per square metre, is converted into the number of hours at the standard intensity of 1,000 W/m² that would deliver the same energy. A day with 5 kWh/m² of irradiation has 5 peak sun hours, whether that energy arrived in a bright midday burst or spread over a long, hazy day.
They make sizing arithmetic easy. Because module ratings are defined at 1,000 W/m², one peak sun hour on a 1 kWp array produces roughly 1 kWh before losses. Multiply kWp by peak sun hours and by a performance ratio and you have a first estimate of daily production.
They vary with season, place and tilt. Peak sun hours are lower in winter, higher closer to the equator and higher on a surface tilted toward the sun than on a horizontal one. A value quoted for horizontal ground is not the value on a tilted roof.
They are a starting point, not a design. A daily average hides the hours that matter: shade falling at 16:00, a hot afternoon cutting module output, an inverter clipping at noon, and a load that peaks after sunset.
Why it matters for solar installers
Peak sun hours are fine for a phone estimate and wrong for a signed proposal. SolarVis replaces them with an 8760-hour simulation of irradiance, shading and electrical yield on the actual roof, matched hour by hour against the customer's consumption. See 3D design and simulation.
Common questions
- Are peak sun hours the same as hours of sunshine?
- No. Hours of sunshine count every hour the sun is visible, whatever its strength. Peak sun hours compress the day's total irradiation into hours of full-strength sun. A summer day with 14 hours of daylight in central Europe might deliver around 5 to 6 peak sun hours.
- How do you estimate solar output from peak sun hours?
- Multiply the array's kWp by the peak sun hours on the plane of the modules and by a performance ratio for losses, often 0.75 to 0.85. A 10 kWp array with 4 peak sun hours and a ratio of 0.8 produces about 32 kWh that day.
- Why are peak sun hours not enough for a proposal?
- They average away the things that decide a real project: shading at particular hours, temperature, orientation, clipping and, above all, when the energy arrives compared with when the building uses it. An hourly simulation captures these; a daily average cannot.